Installing car door lights that shine on the ground is no doubt one of the best ways to amplify your car door system. You don’t need to worry about stepping into a puddle or a muddy part of the road as this is easy to avoid with car door lights.
What is a Car Door LED Projector Light?
A car door LED projector light is also called door logo light. This type of LED light is a small-scale projector made of the famous LED or a light emitting diode. This light is commonly used to light up one’s car door step or to welcome a passenger as a more sophisticated function.
Car door projector lights are usually attached to the car door panel. The image they have is projected on the ground when the car door is open. Of course, as of LEDs characteristics, these car door lights operate automatically and thus there is no other connection needed to install your custom car door lights that shine on the ground.
Car door lights have this kind of sensor called magnetic stripe to work automatically. When you close the door, the car door light will get closer to the magnetic stripe which will turn it off. And when it is open and far from the magnetic stripe, the light turns on.
Car door lights may just go on unnoticed so some passengers may be surprised once they realize them. That is why car door lights are sometimes called ghost shadow lights or car door ghost lights.
How to Install Door Lights that Shine on the Ground
Installing custom door lights that shine on the ground is a piece of cake. Just follow the steps we have set out for you below.
For wired car door lights, you need:
- A projector housing
- Philip and flat screwdrivers
- Retaining ring
- Drill bit
What do you need to do?
Step 1: If it is your first time to install car door lights then this requires you to remove your car door panel. Remove the door lock panel and unscrew all the screwed parts for you to easily remove the panel.
Step 2: Mark the place of the door panel where you want to install your car door light. Drill a hole into that marked area. Once you have it, pass the projector housing and the wires through the hole.
Step 3: Get the retaining ring and pass the wire through it and screw it on the back of the light in the inner side of the car door panel.
Step 4: Connect the car’s dome light and the projector light by tracing them in there. You will need to remove the car door’s inner panels to do this.
Step 5: Once you’ve traced the wires, connect the dome light wire and the projector light wire in the center console.
Step 6: Reinstall every part of the car door panel and you are done!
How to Install Wireless Car Door Lights
Installing wireless car door lights doesn’t need a lot of materials and won’t even take beyond 10 minutes.
First, if your car doesn’t have courtesy lights, then you need to find a spot on the lower part of your car door panel where you want to attach your car door light. Otherwise, you may install your car door light there.
Next, peel the plastic off the sticker or logo and stick it on your car door light. Then, attach the light on your chosen lower spot of your car door panel. As the last step, attach the magnet sensor by using some tape. Make sure to align it to your car door light to make it work. Now, you’re done! Enjoy your stylish and purposeful car door ground lights!
Now that you have obtained the easy steps on installing car door lights, you may want to start searching for your favorite car door light logo. From the brightest LED light bar to your solar powered dusk to dawn light, car door lights will surely complete your energy-efficient LED collection.